Facemill Inserts for aluminium

Hello There, Guest! Register

Thread Modes

Facemill Inserts for aluminium

TomG Offline

Offline

Alt. Whipping Boy

Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan

#7

05-24-2017, 04:36 PM

Wow, those are a lot different than what I got tracking down the part numbers! Too bad Ken isn't around anymore, he was the insert guru.

Tom

Reply

Thanks given by: Wongster

« Next Oldest | Next Newest »

Messages In This Thread

Facemill Inserts for aluminium - by Wongster - 05-24-2017, 03:38 AM

RE: Facemill Inserts for aluminium - by Mayhem - 05-24-2017, 05:21 AM

RE: Facemill Inserts for aluminium - by TomG - 05-24-2017, 08:46 AM

RE: Facemill Inserts for aluminium - by Mayhem - 05-24-2017, 09:17 AM

RE: Facemill Inserts for aluminium - by Wongster - 05-24-2017, 10:41 AM

RE: Facemill Inserts for aluminium - by EdK - 05-24-2017, 04:29 PM

RE: Facemill Inserts for aluminium - by TomG - 05-24-2017, 04:36 PM

RE: Facemill Inserts for aluminium - by Wongster - 05-24-2017, 09:09 PM

RE: Facemill Inserts for aluminium - by Mayhem - 05-25-2017, 05:54 AM

RE: Facemill Inserts for aluminium - by Wongster - 05-25-2017, 11:25 AM

RE: Facemill Inserts for aluminium - by Wongster - 05-25-2017, 12:00 PM

RE: Facemill Inserts for aluminium - by dallen - 05-25-2017, 12:22 PM

RE: Facemill Inserts for aluminium - by Wongster - 05-25-2017, 09:05 PM

RE: Facemill Inserts for aluminium - by Mayhem - 05-26-2017, 06:30 AM

RE: Facemill Inserts for aluminium - by Mayhem - 05-26-2017, 11:02 AM

RE: Facemill Inserts for aluminium - by Wongster - 05-27-2017, 01:20 AM

Users browsing this thread: 2 Guest(s)