removing a tailstock taper

[Vinny]

When you remove the quill, there has to be a hole on the end that's normally in the tail stock. That's where the screw screws in to move it in and out. That's the hole I'm talking about. Also, if the MT2 that's in the tail stock now, if there is one, isn't ejecting when the quill is all the way in, it may be that it's too short. The screw that moves the quill in and out is the screw that ejects the MT2 that's in the quill. If the MT2 that's in the quill is too short, that screw will never touch it so it'll seem that it doesn't have the feature but it really does.