05-19-2017, 07:02 AM
Green Horn here, that why I painted the lathe that colour!
How would I remove a Morse Taper from my tailstock?
It has no thriugh hole to knock it out, it has no side slots to use a wedge in, it's not sophisticated enough to have the feature of back winding the quill to edject it.
The only thing I can think of is if the taper had a shoulder on it I could use a set of wedges as used for drill chuck removal.
How would I remove a Morse Taper from my tailstock?
It has no thriugh hole to knock it out, it has no side slots to use a wedge in, it's not sophisticated enough to have the feature of back winding the quill to edject it.
The only thing I can think of is if the taper had a shoulder on it I could use a set of wedges as used for drill chuck removal.