05-16-2017, 05:41 PM
Mine has two posts sticking out each side near the back then the balance is behind the center hand wheel. Supposedly, when lifted from the posts, there's very little weight at the hand wheel spot. I can't confirm or deny that, I used a forklift!
On another note, mine will have an automatic table soon. I found a pneumatic controller on ebay that works perfectly for it. More on that project when I get further into it.
On another note, mine will have an automatic table soon. I found a pneumatic controller on ebay that works perfectly for it. More on that project when I get further into it.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique