|
The GNAP Bought Another Milling Machine
|
05-10-2017, 11:52 AM
The one thing to look out for is the Y-axis table lock. On mine, when it was locked, the handle stuck up just a bit too far, and cranking on the X can snag and bend it. I added a washer underneath it, so it tightened sooner.
Mike
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
The GNAP Bought Another Milling Machine - by the penguin - 05-03-2017, 05:42 PM
RE: The GNAP Bought Another Milling Machine - by wawoodman - 05-03-2017, 07:06 PM
RE: The GNAP Bought Another Milling Machine - by TomG - 05-03-2017, 11:12 PM
RE: The GNAP Bought Another Milling Machine - by Mayhem - 05-04-2017, 07:54 AM
RE: The GNAP Bought Another Milling Machine - by TomG - 05-04-2017, 08:50 AM
RE: The GNAP Bought Another Milling Machine - by the penguin - 05-09-2017, 05:30 PM
RE: The GNAP Bought Another Milling Machine - by the penguin - 05-09-2017, 05:32 PM
RE: The GNAP Bought Another Milling Machine - by EdK - 05-09-2017, 05:34 PM
RE: The GNAP Bought Another Milling Machine - by pepi - 05-09-2017, 08:49 PM
RE: The GNAP Bought Another Milling Machine - by Dr Stan - 05-10-2017, 02:31 AM
RE: The GNAP Bought Another Milling Machine - by wawoodman - 05-10-2017, 11:52 AM
|
