05-09-2017, 11:55 AM
(This post was last modified: 05-09-2017, 12:02 PM by Mike E..
Edit Reason: spelling
)
I liked your video Steve. I have an old Tom Senior mill which came from a University lab. The table seems fine, but I'm not sure how much wear is on the lead screw, so I'm going to follow your suggestion and offset the vise.
Thanks, I think it's a good idea; just hope I live long enough to wear out the machine.
Thanks, I think it's a good idea; just hope I live long enough to wear out the machine.
Mike