The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Vise Sizing

Thread Modes
Vise Sizing
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
#1
05-05-2017, 12:22 PM
The in coming Rockwell mill, has a 6-1/2" x 24" table, looking for a good milling vise. I have 6" on the other 2 mills (a Jet JVM 836 and the infamous Franken-Mill), wonder on the best size for the Rockwell?? 4"?? or 5"?? or some other size.
jack
Reply
Thanks given by:


Messages In This Thread
Vise Sizing - by the penguin - 05-05-2017, 12:22 PM
RE: Vise Sizing - by wawoodman - 05-05-2017, 01:06 PM
RE: Vise Sizing - by Vinny - 05-05-2017, 01:20 PM
RE: Vise Sizing - by EdK - 05-05-2017, 07:12 PM
RE: Vise Sizing - by Mayhem - 05-05-2017, 07:45 PM
RE: Vise Sizing - by EdK - 05-05-2017, 08:18 PM
RE: Vise Sizing - by Mike E. - 05-06-2017, 06:27 AM
RE: Vise Sizing - by Mayhem - 05-06-2017, 10:47 AM
RE: Vise Sizing - by EdK - 05-06-2017, 11:13 AM
RE: Vise Sizing - by Mike E. - 05-06-2017, 10:57 AM
RE: Vise Sizing - by Dr Stan - 05-06-2017, 12:36 PM



Users browsing this thread: 3 Guest(s)