MetalworkingFun Forum › Machining › General Metalworking Discussion v
Carbide Inserts

Thread Modes
Carbide Inserts
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#6
05-05-2017, 08:45 AM
Can you post a pic of the milling cutters. I suspect they will be the type that will hammer your spindle bearings to death. If that is the case it will be better to offload the inserts.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Carbide Inserts - by Vinny - 05-04-2017, 08:41 AM
RE: Carbide Inserts - by dallen - 05-04-2017, 08:45 AM
RE: Carbide Inserts - by Vinny - 05-04-2017, 09:00 AM
RE: Carbide Inserts - by EdK - 05-04-2017, 11:46 AM
RE: Carbide Inserts - by Vinny - 05-04-2017, 12:44 PM
RE: Carbide Inserts - by Mayhem - 05-05-2017, 08:45 AM
RE: Carbide Inserts - by Vinny - 05-05-2017, 10:35 AM
RE: Carbide Inserts - by Pumpjack - 05-05-2017, 10:52 AM
RE: Carbide Inserts - by f350ca - 05-05-2017, 01:20 PM



Users browsing this thread: 1 Guest(s)