05-04-2017, 11:46 AM
SNMA-433
S = square
N = negative rake
M = dimensional tolerance of the insert
A = center hole for a clamp fastener
4 = 1/2" inscribed circle insert
3 = 3/16" thick
3 = 3/64" edge radius
SPG-433
S = square
P = 11 degree positive rake
G = dimensional tolerance of the insert
4 = 1/2" inscribed circle insert
3 = 3/16" thick
3 = 3/64" edge radius
Those inserts require a tool holder with a 3/4" shank. You'll need a tool holder for the SNMA of this type.
https://www.toolhit.com/collections/turn...srnr-12-4b
Hope this helps some.
Ed
S = square
N = negative rake
M = dimensional tolerance of the insert
A = center hole for a clamp fastener
4 = 1/2" inscribed circle insert
3 = 3/16" thick
3 = 3/64" edge radius
SPG-433
S = square
P = 11 degree positive rake
G = dimensional tolerance of the insert
4 = 1/2" inscribed circle insert
3 = 3/16" thick
3 = 3/64" edge radius
Those inserts require a tool holder with a 3/4" shank. You'll need a tool holder for the SNMA of this type.
https://www.toolhit.com/collections/turn...srnr-12-4b
Hope this helps some.
Ed