|
Drill bits
|
05-04-2017, 07:59 AM
I made up an excel spreadsheet that has all the wire gauge, letter, fractional and metric drills up to 1" / 25mm and the recommended RPM for a variety of materials. I printed it out, laminated it and it hangs next to the drill press. I'll see if I can dig it up and I'll post it here.
Hunting American dentists since 2015.
Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Drill bits - by pepi - 04-10-2017, 08:30 PM
RE: Drill bits - by Vinny - 04-10-2017, 08:33 PM
RE: Drill bits - by TomG - 04-10-2017, 08:50 PM
RE: Drill bits - by rleete - 04-11-2017, 08:22 AM
RE: Drill bits - by pepi - 04-11-2017, 10:47 PM
RE: Drill bits - by rleete - 04-12-2017, 08:15 AM
RE: Drill bits - by Fortis - 04-22-2017, 12:11 AM
RE: Drill bits - by wawoodman - 04-23-2017, 12:01 AM
RE: Drill bits - by Dr Stan - 04-23-2017, 12:22 AM
RE: Drill bits - by Vinny - 04-23-2017, 12:42 AM
RE: Drill bits - by pepi - 04-23-2017, 06:46 AM
RE: Drill bits - by EdK - 04-23-2017, 12:38 PM
RE: Drill bits - by wawoodman - 04-23-2017, 07:26 PM
RE: Drill bits - by pepi - 05-02-2017, 03:08 PM
RE: Drill bits - by Mayhem - 05-03-2017, 06:58 AM
RE: Drill bits - by pepi - 05-03-2017, 08:07 AM
RE: Drill bits - by TomG - 05-03-2017, 08:21 AM
RE: Drill bits - by pepi - 05-03-2017, 12:39 PM
RE: Drill bits - by Mayhem - 05-04-2017, 07:59 AM
RE: Drill bits - by pepi - 05-04-2017, 09:58 PM
RE: Drill bits - by toglhot - 05-12-2017, 02:41 AM
RE: Drill bits - by Mayhem - 06-14-2017, 07:47 AM
|
