Harrison Milling Machine

[Zoot Suit]

Thanks Phil, a picture and dimensions would be great.  Mine came with a hand wheel on the knee, only about 5" in diameter so way too small.  I looked at the picture of a machine on lathes.co.uk and it would seem that the original configuration for the machine was a handle not a wheel.  I will go with a handle as it makes so much more sense than a small wheel especially if there is something heavy on the table and you want to raise it up.

Alkyd enamel was a type of paint on my list of possible paints but I haven't used it before.  Its good to hear about your first hand experience of using it.  I will order some and some primer.  I wouldn't use 2 pack without an air fed mask, my health is too precious.

Thanks again,

John