Drill bits

Thread Modes

Drill bits

Mayhem Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#15

05-03-2017, 06:58 AM

(05-02-2017, 03:08 PM)pepi Wrote: ...Oh and was told to run his bits 350 and below...

Greg

Personally, I set the RPM to suit the diameter of the drill and the material being drilled.

Hunting American dentists since 2015.

« Next Oldest | Next Newest »

Messages In This Thread

Drill bits - by pepi - 04-10-2017, 08:30 PM

RE: Drill bits - by Vinny - 04-10-2017, 08:33 PM

RE: Drill bits - by TomG - 04-10-2017, 08:50 PM

RE: Drill bits - by rleete - 04-11-2017, 08:22 AM

RE: Drill bits - by pepi - 04-11-2017, 10:47 PM

RE: Drill bits - by rleete - 04-12-2017, 08:15 AM

RE: Drill bits - by Fortis - 04-22-2017, 12:11 AM

RE: Drill bits - by wawoodman - 04-23-2017, 12:01 AM

RE: Drill bits - by Dr Stan - 04-23-2017, 12:22 AM

RE: Drill bits - by Vinny - 04-23-2017, 12:42 AM

RE: Drill bits - by pepi - 04-23-2017, 06:46 AM

RE: Drill bits - by EdK - 04-23-2017, 12:38 PM

RE: Drill bits - by wawoodman - 04-23-2017, 07:26 PM

RE: Drill bits - by pepi - 05-02-2017, 03:08 PM

RE: Drill bits - by Mayhem - 05-03-2017, 06:58 AM

RE: Drill bits - by pepi - 05-03-2017, 08:07 AM

RE: Drill bits - by TomG - 05-03-2017, 08:21 AM

RE: Drill bits - by pepi - 05-03-2017, 12:39 PM

RE: Drill bits - by Mayhem - 05-04-2017, 07:59 AM

RE: Drill bits - by pepi - 05-04-2017, 09:58 PM

RE: Drill bits - by toglhot - 05-12-2017, 02:41 AM

RE: Drill bits - by Mayhem - 06-14-2017, 07:47 AM

Users browsing this thread: 3 Guest(s)