05-03-2017, 06:37 AM
Re the motors. I am aware of the differing voltages and single vs three phase. My intention is to run the main motor through a phase converter at 230volts three phase as its a dual voltage unit. I want to use a 230 volt three phase motor for the small motor also through a separate phase converter to give the option of varying table feed electrically as well as by change gear. (I thought I had mentioned this previously above). I had assumed that it would be difficult to find a new motor to fit without having to modify the motor or gearbox or build some sort of adapter hence why I am looking at rewind options first. If I cant get it rewound then I have some ideas for a Plan B.
Re the missing overarm I have a plan for that which will be phase two of this project.
Re the 2 part urethane paint. I had a look online and most sites say it also contains isocyanates so an air fed mask is required. I am led to believe that all 2 part paints contain isocyanates. I will have to do some more reading about the paint possibilities.
John
Re the missing overarm I have a plan for that which will be phase two of this project.
Re the 2 part urethane paint. I had a look online and most sites say it also contains isocyanates so an air fed mask is required. I am led to believe that all 2 part paints contain isocyanates. I will have to do some more reading about the paint possibilities.
John