05-02-2017, 03:08 PM
Still got this bug for a new set of good drill bits, anyone know or have used these.
http://www.wintersdrillbitcity.com/
They are on my radar, have talked with the owner, sent me his catalog (PDF). A best drill bits search done, these were mentioned on a practical machinist, thread .
Told no pre-drilling, what I call a pilot hole needed, fractions have flats & sells single bits if ya brake one, happens now and then.
Oh and was told to run his bits 350 and below, that btw is something I have started doing since I acquired the mill. Lowered the drill speed using the press also.
All ears or eyes in this case tell me what you think..please
Greg
http://www.wintersdrillbitcity.com/
They are on my radar, have talked with the owner, sent me his catalog (PDF). A best drill bits search done, these were mentioned on a practical machinist, thread .
Told no pre-drilling, what I call a pilot hole needed, fractions have flats & sells single bits if ya brake one, happens now and then.
Oh and was told to run his bits 350 and below, that btw is something I have started doing since I acquired the mill. Lowered the drill speed using the press also.
All ears or eyes in this case tell me what you think..please
Greg
Magazines have issues, everything else has problems