So, in my usual, clueless purchase mode, I have taken posession of a Boyar-Schultz OC knurling and burnishing tool, with a set of straight knurls. It seemed like a good idea at the time...
So I'm sure I can fumble my way through, but if anybody has some suggestions or instructions, it would sure be a good thing! Oddly enough, nothing at all on YouTube.
The first step will be figuring out how to hold it on the lathe. It has a 1" shank, but that's removeable, down to the 3/4" integral shank. IIRC, the South Bend has a 3MT in the tailstock, so I can get a collet that should work.
Any further instruction will be gratefully accepted!
So I'm sure I can fumble my way through, but if anybody has some suggestions or instructions, it would sure be a good thing! Oddly enough, nothing at all on YouTube.
The first step will be figuring out how to hold it on the lathe. It has a 1" shank, but that's removeable, down to the 3/4" integral shank. IIRC, the South Bend has a 3MT in the tailstock, so I can get a collet that should work.
Any further instruction will be gratefully accepted!
Mike
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)