Table for my mill

[Vinny]

For the most part it's finished. After rereading this thread I remember that I planned on putting angle in the bottom and put a shelf on it. Not sure if I'll still do that. I'm currently out of angle (easily remedied) and I do need the horizontal space, but it's already painted. I'll have to think on it some, then go and get more angle.

It was pulsating again and I didn't want to be bothered with it since wire speed wasn't helping, so I kicked up the heat and it stopped doing that. Welds weren't as pretty but there were puddles going on. There are only 4 heat settings. Min/Max 1/2. It was in Max/1 so I switched it to Max/2. Haven't looked at the contactor yet, should do that one evening this week splitting time with cleaning out the old bench. That bench has to go before the new stand/table can be put in place. That may only be temporary tho as I've got my eye on a Bridgeport.

Here's a pic of what it looks like now. I also just remembered the levelers aren't on it either, if I only remembered where I put 'em.