MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drill bits

Thread Modes
Drill bits
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#9
04-23-2017, 12:22 AM
I have the 750 and have had good service out of it.  One of the better aspects is its sharpening carbide drills.

BTW, +whatever on the coatings.  The ends of the flutes are what cut the material, not the sides, so they are not worth the extra money.
Reply
Thanks given by:


Messages In This Thread
Drill bits - by pepi - 04-10-2017, 08:30 PM
RE: Drill bits - by Vinny - 04-10-2017, 08:33 PM
RE: Drill bits - by TomG - 04-10-2017, 08:50 PM
RE: Drill bits - by rleete - 04-11-2017, 08:22 AM
RE: Drill bits - by pepi - 04-11-2017, 10:47 PM
RE: Drill bits - by rleete - 04-12-2017, 08:15 AM
RE: Drill bits - by Fortis - 04-22-2017, 12:11 AM
RE: Drill bits - by wawoodman - 04-23-2017, 12:01 AM
RE: Drill bits - by Dr Stan - 04-23-2017, 12:22 AM
RE: Drill bits - by Vinny - 04-23-2017, 12:42 AM
RE: Drill bits - by pepi - 04-23-2017, 06:46 AM
RE: Drill bits - by EdK - 04-23-2017, 12:38 PM
RE: Drill bits - by wawoodman - 04-23-2017, 07:26 PM
RE: Drill bits - by pepi - 05-02-2017, 03:08 PM
RE: Drill bits - by Mayhem - 05-03-2017, 06:58 AM
RE: Drill bits - by pepi - 05-03-2017, 08:07 AM
RE: Drill bits - by TomG - 05-03-2017, 08:21 AM
RE: Drill bits - by pepi - 05-03-2017, 12:39 PM
RE: Drill bits - by Mayhem - 05-04-2017, 07:59 AM
RE: Drill bits - by pepi - 05-04-2017, 09:58 PM
RE: Drill bits - by toglhot - 05-12-2017, 02:41 AM
RE: Drill bits - by Mayhem - 06-14-2017, 07:47 AM



Users browsing this thread: 2 Guest(s)