MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drill bits

Thread Modes
Drill bits
rleete Offline
Senior
*****
Posts: 771
Threads: 48
Joined: Mar 2012
Location: Rochester, NY
#4
04-11-2017, 08:22 AM
A drill Doctor will take even the cheapest bits and make them usable, provided they are not bent. Best 20 bucks (used) I ever spent.

Buy cheap sets, sharpen before use. Coatings make little difference as far as I have seen.
Full of ideas, but slow to produce parts
Reply
Thanks given by:


Messages In This Thread
Drill bits - by pepi - 04-10-2017, 08:30 PM
RE: Drill bits - by Vinny - 04-10-2017, 08:33 PM
RE: Drill bits - by TomG - 04-10-2017, 08:50 PM
RE: Drill bits - by rleete - 04-11-2017, 08:22 AM
RE: Drill bits - by pepi - 04-11-2017, 10:47 PM
RE: Drill bits - by rleete - 04-12-2017, 08:15 AM
RE: Drill bits - by Fortis - 04-22-2017, 12:11 AM
RE: Drill bits - by wawoodman - 04-23-2017, 12:01 AM
RE: Drill bits - by Dr Stan - 04-23-2017, 12:22 AM
RE: Drill bits - by Vinny - 04-23-2017, 12:42 AM
RE: Drill bits - by pepi - 04-23-2017, 06:46 AM
RE: Drill bits - by EdK - 04-23-2017, 12:38 PM
RE: Drill bits - by wawoodman - 04-23-2017, 07:26 PM
RE: Drill bits - by pepi - 05-02-2017, 03:08 PM
RE: Drill bits - by Mayhem - 05-03-2017, 06:58 AM
RE: Drill bits - by pepi - 05-03-2017, 08:07 AM
RE: Drill bits - by TomG - 05-03-2017, 08:21 AM
RE: Drill bits - by pepi - 05-03-2017, 12:39 PM
RE: Drill bits - by Mayhem - 05-04-2017, 07:59 AM
RE: Drill bits - by pepi - 05-04-2017, 09:58 PM
RE: Drill bits - by toglhot - 05-12-2017, 02:41 AM
RE: Drill bits - by Mayhem - 06-14-2017, 07:47 AM



Users browsing this thread: 3 Guest(s)