MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe chuck jaws

Thread Modes
Lathe chuck jaws
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
#11
03-21-2017, 06:57 PM
Hello.

chucks are for workholding .. chucks are not precision. collets will get you close to to being repeatable but a struggle. have a chuck that can be nudged.

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Lathe chuck jaws - by Wongster - 03-20-2017, 11:06 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 07:06 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 07:19 AM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 10:57 AM
RE: Lathe chuck jaws - by Wongster - 03-21-2017, 07:53 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 08:03 AM
RE: Lathe chuck jaws - by f350ca - 03-21-2017, 08:50 AM
RE: Lathe chuck jaws - by Vinny - 03-21-2017, 11:13 AM
RE: Lathe chuck jaws - by EdK - 03-21-2017, 05:22 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 05:57 PM
RE: Lathe chuck jaws - by ieezitin - 03-21-2017, 06:57 PM
RE: Lathe chuck jaws - by EdK - 03-22-2017, 05:27 AM
RE: Lathe chuck jaws - by stevec - 03-22-2017, 06:29 AM
RE: Lathe chuck jaws - by awemawson - 03-22-2017, 06:57 AM
RE: Lathe chuck jaws - by Roadracer_Al - 03-22-2017, 11:29 AM
RE: Lathe chuck jaws - by Wongster - 03-22-2017, 11:47 AM



Users browsing this thread: 2 Guest(s)