MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe chuck jaws

Thread Modes
Lathe chuck jaws
pepi Offline
Courious
****
Posts: 432
Threads: 27
Joined: Feb 2016
Location: Woodstock:GA
#10
03-21-2017, 05:57 PM
Vinny,
Yeah I notice that wood connection when I looked the chuck up. I think carving new jaws would be a job. Milled alum shims and spot super gluing them to the jaw face would give him a soft grip he is looking for.

Greg
Magazines have issues, everything else has problems

Reply
Thanks given by:


Messages In This Thread
Lathe chuck jaws - by Wongster - 03-20-2017, 11:06 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 07:06 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 07:19 AM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 10:57 AM
RE: Lathe chuck jaws - by Wongster - 03-21-2017, 07:53 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 08:03 AM
RE: Lathe chuck jaws - by f350ca - 03-21-2017, 08:50 AM
RE: Lathe chuck jaws - by Vinny - 03-21-2017, 11:13 AM
RE: Lathe chuck jaws - by EdK - 03-21-2017, 05:22 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 05:57 PM
RE: Lathe chuck jaws - by ieezitin - 03-21-2017, 06:57 PM
RE: Lathe chuck jaws - by EdK - 03-22-2017, 05:27 AM
RE: Lathe chuck jaws - by stevec - 03-22-2017, 06:29 AM
RE: Lathe chuck jaws - by awemawson - 03-22-2017, 06:57 AM
RE: Lathe chuck jaws - by Roadracer_Al - 03-22-2017, 11:29 AM
RE: Lathe chuck jaws - by Wongster - 03-22-2017, 11:47 AM



Users browsing this thread: 4 Guest(s)