03-21-2017, 10:57 AM
(03-21-2017, 07:19 AM)Mayhem Wrote: Hi Greg - have you ever tried to grab square stock with a 3-jaw chuck? To do so, you need to find a section of pipe that fits, or bore one that will and then slit it. Then you can grab square stock in a 3-jaw. However, with a 4-jaw scroll, you just throw it in and tighten the jaws.
Must say no to that, cause I have a 4 jaw for that
, the more time I spend using the 4 jaw the better/faster I'm getting with it. Do think the scrolling type will have the advantage if work requires removal. For a test fit and needs to be chucked for finishing. That could get a bit dicey with the independent 4 jaw if not paying attention.
Always good to find out about another way, for no other reason, but for the knowledge gained.
Greg
Magazines have issues, everything else has problems