MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe chuck jaws

Thread Modes
Lathe chuck jaws
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#5
03-21-2017, 08:03 AM
Having never used two-piece jaws before, I'll let someone more experienced respond. However, the ones I have seen used appear to have a raised key that runs perpendicular to the length of the jaw to locate the soft jaw section.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Lathe chuck jaws - by Wongster - 03-20-2017, 11:06 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 07:06 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 07:19 AM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 10:57 AM
RE: Lathe chuck jaws - by Wongster - 03-21-2017, 07:53 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 08:03 AM
RE: Lathe chuck jaws - by f350ca - 03-21-2017, 08:50 AM
RE: Lathe chuck jaws - by Vinny - 03-21-2017, 11:13 AM
RE: Lathe chuck jaws - by EdK - 03-21-2017, 05:22 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 05:57 PM
RE: Lathe chuck jaws - by ieezitin - 03-21-2017, 06:57 PM
RE: Lathe chuck jaws - by EdK - 03-22-2017, 05:27 AM
RE: Lathe chuck jaws - by stevec - 03-22-2017, 06:29 AM
RE: Lathe chuck jaws - by awemawson - 03-22-2017, 06:57 AM
RE: Lathe chuck jaws - by Roadracer_Al - 03-22-2017, 11:29 AM
RE: Lathe chuck jaws - by Wongster - 03-22-2017, 11:47 AM



Users browsing this thread: 1 Guest(s)