03-21-2017, 07:19 AM
Hi Wongster - not a silly question, but not one that I can answer for you. However, I do recall seeing a post or youtube video on machining jaws to fit a scroll. However, I cannot recall where I saw it. You could always aneal a set of jaws and then modify them to accept a soft jaw. I think that stevec may have done this in the past and posted it here.
Hi Greg - have you ever tried to grab square stock with a 3-jaw chuck? To do so, you need to find a section of pipe that fits, or bore one that will and then slit it. Then you can grab square stock in a 3-jaw. However, with a 4-jaw scroll, you just throw it in and tighten the jaws.
Hi Greg - have you ever tried to grab square stock with a 3-jaw chuck? To do so, you need to find a section of pipe that fits, or bore one that will and then slit it. Then you can grab square stock in a 3-jaw. However, with a 4-jaw scroll, you just throw it in and tighten the jaws.
Hunting American dentists since 2015.