|
Lathe chuck jaws
|
03-21-2017, 07:06 AM
Maybe mill some precise shims to place over the jaws. Must say I never knew the was a self centering 4 jaw. I'm missing something I am sure, what is the advantage of a 4 jaw self adjusting over a 3 jaw?
So far as a pattern you have that, duplicating it will be some work.. I can tell you that. Greg
Magazines have issues, everything else has problems
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe chuck jaws - by Wongster - 03-20-2017, 11:06 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 07:06 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 07:19 AM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 10:57 AM
RE: Lathe chuck jaws - by Wongster - 03-21-2017, 07:53 AM
RE: Lathe chuck jaws - by Mayhem - 03-21-2017, 08:03 AM
RE: Lathe chuck jaws - by f350ca - 03-21-2017, 08:50 AM
RE: Lathe chuck jaws - by Vinny - 03-21-2017, 11:13 AM
RE: Lathe chuck jaws - by EdK - 03-21-2017, 05:22 PM
RE: Lathe chuck jaws - by pepi - 03-21-2017, 05:57 PM
RE: Lathe chuck jaws - by ieezitin - 03-21-2017, 06:57 PM
RE: Lathe chuck jaws - by EdK - 03-22-2017, 05:27 AM
RE: Lathe chuck jaws - by stevec - 03-22-2017, 06:29 AM
RE: Lathe chuck jaws - by awemawson - 03-22-2017, 06:57 AM
RE: Lathe chuck jaws - by Roadracer_Al - 03-22-2017, 11:29 AM
RE: Lathe chuck jaws - by Wongster - 03-22-2017, 11:47 AM
|
