03-14-2017, 06:51 AM
Tom,
Exactly the very thought that went thru my mind when thinking about the usage.
Most recently, like yesterday saw your video showing and explaining a handy method of reaching the OD of a piece. The desired end result was to be 1.125, the part turned was too large @ .0120. I believe you set up the next cut @ .120....
Thinking why not .060, then I read some lathes can read a cross feed radius, ever heard of this?
Greg
Exactly the very thought that went thru my mind when thinking about the usage.
Most recently, like yesterday saw your video showing and explaining a handy method of reaching the OD of a piece. The desired end result was to be 1.125, the part turned was too large @ .0120. I believe you set up the next cut @ .120....
Thinking why not .060, then I read some lathes can read a cross feed radius, ever heard of this?
Greg
Magazines have issues, everything else has problems