|
Wondering about a t&c grinder
|
02-27-2017, 11:47 PM
I have a Clarckson t&c grinder. I don't use it very often, but I do have a lot of horizontal cutters and endmills. I have enjoyed getting a good edge on the ones I've sharpened. If you can get it for a good price, I say go for it.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Wondering about a t&c grinder - by Pete O - 02-27-2017, 07:26 AM
RE: Wondering about a t&c grinder - by TomG - 02-27-2017, 05:46 PM
RE: Wondering about a t&c grinder - by Hawkeye - 02-27-2017, 11:47 PM
RE: Wondering about a t&c grinder - by Pete O - 02-28-2017, 12:25 AM
RE: Wondering about a t&c grinder - by Dr Stan - 02-28-2017, 12:39 AM
RE: Wondering about a t&c grinder - by Vinny - 02-28-2017, 12:37 PM
RE: Wondering about a t&c grinder - by Dr Stan - 02-28-2017, 01:52 PM
RE: Wondering about a t&c grinder - by Dr Stan - 03-08-2017, 12:12 AM
RE: Wondering about a t&c grinder - by Mayhem - 02-28-2017, 05:13 AM
RE: Wondering about a t&c grinder - by Pete O - 03-06-2017, 10:19 PM
RE: Wondering about a t&c grinder - by Dr Stan - 03-07-2017, 12:31 PM
RE: Wondering about a t&c grinder - by Pete O - 03-07-2017, 04:22 PM
RE: Wondering about a t&c grinder - by Vinny - 03-08-2017, 04:07 PM
|
