02-25-2017, 11:46 PM
The set of holes that looked like they were pilot holes were not. Actually the were for this silly drawing, and the reason? Created a template to tape on the side of the bucket, center punch and drill.
Then flipped the mount and finished the welding.
Using the edge finder locating the hole center, drilled them to .5 for the fasteners, I used tap magic for the drilling to see what the results would be. It punched some really clean holes, will try that some more.
painted.. done picked up
Want to mention that this edge finder is very nice, dual purpose. It chucks to the center section. Second the hole finder is used statically, can be used with a drill press. Get the hole drilled where the center pinch left its mark...
That's all folks,
Greg
Then flipped the mount and finished the welding.
Using the edge finder locating the hole center, drilled them to .5 for the fasteners, I used tap magic for the drilling to see what the results would be. It punched some really clean holes, will try that some more.
painted.. done picked up
Want to mention that this edge finder is very nice, dual purpose. It chucks to the center section. Second the hole finder is used statically, can be used with a drill press. Get the hole drilled where the center pinch left its mark...
That's all folks,
Greg
Magazines have issues, everything else has problems