MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Another Spring Tool Holder

Thread Modes
Another Spring Tool Holder
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#14
02-13-2017, 11:35 PM
Keep in mind that, in a shaper, the shaft of the tool would be vertical, not horizontal as in a lathe. It is possible that it would function in a shaper, if it had the proper spring action.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Another Spring Tool Holder - by Hawkeye - 02-18-2014, 09:18 PM
RE: Another Spring Tool Holder - by f350ca - 02-18-2014, 10:59 PM
RE: Another Spring Tool Holder - by DaveH - 02-19-2014, 05:41 AM
RE: Another Spring Tool Holder - by stevec - 02-19-2014, 08:15 AM
RE: Another Spring Tool Holder - by EdK - 02-19-2014, 05:07 PM
RE: Another Spring Tool Holder - by Hawkeye - 02-19-2014, 09:25 PM
RE: Another Spring Tool Holder - by arvidj - 02-05-2017, 11:03 AM
RE: Another Spring Tool Holder - by ieezitin - 02-05-2017, 07:47 PM
RE: Another Spring Tool Holder - by Hawkeye - 02-05-2017, 11:31 PM
RE: Another Spring Tool Holder - by Roadracer_Al - 02-12-2017, 01:22 PM
RE: Another Spring Tool Holder - by stevec - 02-13-2017, 07:46 AM
RE: Another Spring Tool Holder - by Hawkeye - 02-12-2017, 11:52 PM
RE: Another Spring Tool Holder - by Mayhem - 02-13-2017, 09:15 AM
RE: Another Spring Tool Holder - by Hawkeye - 02-13-2017, 11:35 PM
RE: Another Spring Tool Holder - by awemawson - 02-14-2017, 01:41 AM
RE: Another Spring Tool Holder - by ieezitin - 02-14-2017, 05:12 PM
RE: Another Spring Tool Holder - by Roadracer_Al - 02-17-2017, 01:24 PM



Users browsing this thread: 5 Guest(s)