MetalworkingFun Forum › Machining › General Metalworking Discussion v
Anyone seen one of these before?

Thread Modes
Anyone seen one of these before?
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#6
01-27-2017, 07:40 PM
(01-27-2017, 07:48 AM)pepi Wrote: How do you figure that the pined shafts look like they have a smaller OD?

I never said it was assembled incorrectly.

Ed
Reply
Thanks given by:


Messages In This Thread
Anyone seen one of these before? - by Dr Stan - 01-26-2017, 11:55 PM
RE: Anyone seen one of these before? - by EdK - 01-27-2017, 06:22 AM
RE: Anyone seen one of these before? - by pepi - 01-27-2017, 07:48 AM
RE: Anyone seen one of these before? - by Vinny - 01-27-2017, 10:04 AM
RE: Anyone seen one of these before? - by EdK - 01-27-2017, 07:40 PM
RE: Anyone seen one of these before? - by Mayhem - 01-27-2017, 08:20 PM
RE: Anyone seen one of these before? - by Dr Stan - 01-28-2017, 12:35 AM



Users browsing this thread: 1 Guest(s)