MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Small Boring tools

Thread Modes
Small Boring tools
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Dr Stan (01-21-2017)
#5
01-21-2017, 08:02 PM
(01-21-2017, 05:10 PM)wawoodman Wrote: Tom,
Would a 4-flute be center cutting? I was under the impression that (generally) 2-flute are, and 4-flute aren't. Or, can you find it if you look for it?

Yes, you can get both 4-flute and 2-flute end mills that are center cutting. That's the only type I buy.

Ed
Reply
Thanks given by:


Messages In This Thread
Small Boring tools - by RandaB - 01-21-2017, 02:57 PM
RE: Small Boring tools - by TomG - 01-21-2017, 03:12 PM
RE: Small Boring tools - by wawoodman - 01-21-2017, 05:10 PM
RE: Small Boring tools - by EdK - 01-21-2017, 08:02 PM
RE: Small Boring tools - by f350ca - 01-21-2017, 06:14 PM
RE: Small Boring tools - by wawoodman - 01-22-2017, 01:12 PM
RE: Small Boring tools - by ieezitin - 01-22-2017, 07:34 PM
RE: Small Boring tools - by wawoodman - 01-22-2017, 08:21 PM



Users browsing this thread: 3 Guest(s)