|
Small Boring tools
|
|
01-21-2017, 03:12 PM
You know, end mills make very nice boring bars in a pinch. 1/4"x1" long four flute end mills are readily available over here, so I imagine something suitable is available over there as well. Just set them up on center and slightly angled to get some clearance. Obviously, use the largest one practical.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Small Boring tools - by RandaB - 01-21-2017, 02:57 PM
RE: Small Boring tools - by TomG - 01-21-2017, 03:12 PM
RE: Small Boring tools - by wawoodman - 01-21-2017, 05:10 PM
RE: Small Boring tools - by EdK - 01-21-2017, 08:02 PM
RE: Small Boring tools - by f350ca - 01-21-2017, 06:14 PM
RE: Small Boring tools - by wawoodman - 01-22-2017, 01:12 PM
RE: Small Boring tools - by ieezitin - 01-22-2017, 07:34 PM
RE: Small Boring tools - by wawoodman - 01-22-2017, 08:21 PM
|
