MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drill sharpening jig

Thread Modes
Drill sharpening jig
toglhot Offline
Sophmore
***
Posts: 62
Threads: 30
Joined: Jan 2017
Location: Australia
#4
01-18-2017, 05:06 AM
(01-17-2017, 10:17 PM)pepi Wrote: Very nice what is the smallest bit you are able to sharpen?

Greg

Probably around 3mm, anything smaller would require a better indexing system I think.
Reply
Thanks given by:


Messages In This Thread
Drill sharpening jig - by toglhot - 01-17-2017, 08:23 PM
RE: Drill sharpening jig - by toglhot - 01-17-2017, 08:36 PM
RE: Drill sharpening jig - by pepi - 01-17-2017, 10:17 PM
RE: Drill sharpening jig - by toglhot - 01-18-2017, 05:06 AM
RE: Drill sharpening jig - by toglhot - 01-18-2017, 05:25 AM
RE: Drill sharpening jig - by Mayhem - 01-18-2017, 08:27 AM
RE: Drill sharpening jig - by Dr Stan - 01-19-2017, 08:39 PM
RE: Drill sharpening jig - by krv3000 - 01-19-2017, 04:49 PM



Users browsing this thread: 1 Guest(s)