[PROJECT] Clamp Knurling Tool

[EdK]

(01-14-2017, 04:32 PM)TomG Wrote: ...

I can't tell from the pic, but be sure the knurls are slightly chamfered before trying it out. Otherwise, they may dig into the work.

Tom

Now that I think of it, those knurls are not chamfered and are actually meant for my cut knurling tool project I may tackle some day. I might have grabbed the wrong knurls
Anyway, what TPI knurls do you use the most? The ones I've got on the tool are pretty fine so, since I'm doing a McMaster order, I think I'll get some properly chamfered knurls.

Ed

EDIT: those knurls were not meant for my cut knurling tool project. I got them from McMaster for this project. Now I'm wondering about a source for the beveled edge knurls. They seem to be as scarce as hen's teeth.