12-28-2016, 01:17 PM
Sorry Andrew couldn't resist that one!
The product I'm using is a gun bluing solution from Brownells called Oxpho Blue.
My method was as follows,
1. De rust
2. Wire brush
3. De grease
4. Apply Oxpho
5. Rinse with water
6. Wire wool (fine grade)
7. Re apply Oxpho
8. Submerge part into old engine or wipe over with old engine oil depending on size etc.
The finish seems to vary between parts I guess because of the base metal. But even the worst finish looks acceptable to me.
Cheers
John
The product I'm using is a gun bluing solution from Brownells called Oxpho Blue.
My method was as follows,
1. De rust
2. Wire brush
3. De grease
4. Apply Oxpho
5. Rinse with water
6. Wire wool (fine grade)
7. Re apply Oxpho
8. Submerge part into old engine or wipe over with old engine oil depending on size etc.
The finish seems to vary between parts I guess because of the base metal. But even the worst finish looks acceptable to me.
Cheers
John