12-25-2016, 07:22 AM
Why do you want blueprints? You are not going to build anything remotely close to resembling your wish list. Further, you haven't told us anything about the specifications for the mill.
Your only options in Australia are to buy used, which generally means whatever you can find and make do with, or you buy new from Hare & Forbes (expensive) or try importing from OS.
Keep in mind that you will spend two to three times the cost of the machines in tooling and for most, this is accumulated over a number of years. That is unless you win the lotto, inherit a bucket load of money or are going to take out a loan.
Finally, .001" work accuracy comes down to the operator's ability much more than the machines quality or tolerances. There are guys on this forum who can get better than .001" on old, worn machines, whilst there are people out there who would struggle to get to within .005" on the most expensive precision lathe.
For us to be most helpful to you, it would be useful to know what you are intending to use the machines for. Also, ER collets are probably a better choice if starting from scratch, as both can easily be used in the lathe and mill.
Your only options in Australia are to buy used, which generally means whatever you can find and make do with, or you buy new from Hare & Forbes (expensive) or try importing from OS.
Keep in mind that you will spend two to three times the cost of the machines in tooling and for most, this is accumulated over a number of years. That is unless you win the lotto, inherit a bucket load of money or are going to take out a loan.
Finally, .001" work accuracy comes down to the operator's ability much more than the machines quality or tolerances. There are guys on this forum who can get better than .001" on old, worn machines, whilst there are people out there who would struggle to get to within .005" on the most expensive precision lathe.
For us to be most helpful to you, it would be useful to know what you are intending to use the machines for. Also, ER collets are probably a better choice if starting from scratch, as both can easily be used in the lathe and mill.
Hunting American dentists since 2015.