12-23-2016, 11:53 PM
I picked up a selection of adjustable reamers a few years ago. Some are quite large, so I needed a tap wrench that could accommodate the various sizes. I finally got around to it today. The end of the reamer is nearly 1 1/4" square.
A little light knurling to improve the grip.
A little light knurling to improve the grip.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.