MetalworkingFun Forum › Machining › General Metalworking Discussion v
An Interesting YouTube Channel

Thread Modes
An Interesting YouTube Channel
Mike E. Offline
Sophmore
***
Posts: 239
Threads: 2
Joined: Sep 2016
Location: California & Wales Home & Home Away
#17
12-10-2016, 03:20 PM
(10-15-2016, 08:09 AM)schor Wrote: ........... He has a thread on one of the machining forums when he restored his surface grinder, it was a great thread and showed he knows what he is doing.

I followed those videos. Have been looking for a older manual surface grinder for awhile, and now I know what I'm probably up against.
Mike
Reply
Thanks given by:


Messages In This Thread
An Interesting YouTube Channel - by TomG - 10-08-2016, 08:36 AM
RE: An Interesting YouTube Channel - by EdK - 10-08-2016, 08:58 AM
RE: An Interesting YouTube Channel - by Highpower - 10-08-2016, 01:48 PM
RE: An Interesting YouTube Channel - by f350ca - 10-08-2016, 10:58 AM
RE: An Interesting YouTube Channel - by EdK - 10-08-2016, 03:09 PM
RE: An Interesting YouTube Channel - by Highpower - 10-09-2016, 12:24 PM
RE: An Interesting YouTube Channel - by texx - 10-08-2016, 03:24 PM
RE: An Interesting YouTube Channel - by Highpower - 10-09-2016, 12:21 PM
RE: An Interesting YouTube Channel - by Vinny - 10-10-2016, 06:13 PM
RE: An Interesting YouTube Channel - by EdK - 10-10-2016, 07:17 PM
RE: An Interesting YouTube Channel - by Vinny - 10-10-2016, 07:33 PM
RE: An Interesting YouTube Channel - by EdK - 10-12-2016, 05:57 PM
RE: An Interesting YouTube Channel - by schor - 10-15-2016, 08:09 AM
RE: An Interesting YouTube Channel - by Seanlogie - 12-04-2016, 12:14 PM
RE: An Interesting YouTube Channel - by Mike E. - 12-10-2016, 03:20 PM



Users browsing this thread: 1 Guest(s)