12-04-2016, 11:21 AM
Hi Guys
Well, seeing that the Lathe is only going to be repaired on Monday, we could not wait much longer to finish our project
These were the Machinist's Jacks that we intended for a long while, and which we missed badly when working on the Wheel Balancing Stand
We continued with the Threading, albeit on the wrong Shift Lever Number, and then simply used our 22 mm 2" Die in the Stock we recently acquired from the Pawn Shop.
Engaged the Feed at low speed and the Lathe did the balance.
And Bob's Your Uncle, worked like a charm
The pic shows these completed
However, Monday is "D" day and we hope the bill is reasonable, LORD Willing
Will keep U Guys posted
aRM
Well, seeing that the Lathe is only going to be repaired on Monday, we could not wait much longer to finish our project
These were the Machinist's Jacks that we intended for a long while, and which we missed badly when working on the Wheel Balancing Stand
We continued with the Threading, albeit on the wrong Shift Lever Number, and then simply used our 22 mm 2" Die in the Stock we recently acquired from the Pawn Shop.
Engaged the Feed at low speed and the Lathe did the balance.
And Bob's Your Uncle, worked like a charm
The pic shows these completed
However, Monday is "D" day and we hope the bill is reasonable, LORD Willing
Will keep U Guys posted
aRM