12-01-2016, 11:02 PM
(12-01-2016, 10:33 PM)Dr Stan Wrote: OK, another question. Can you rotate the spindle by hand?
DOC, usually do that when changing Speeds
And it is a bit difficult in the much slower speeds
However, i need to try that now whilst -re-setting all the Gear Levers and then see if we can get the Gears to mesh whilst coaxing the Shifting Lever to 6th
Must thank all U Guys for Your input here.
Sorry I could not come back to You'll earlier, this site kept freezing on me yesterday.
In the interim got me a Die Stock yesterday, as I had the Adjustable Round Split 22 Die, to tackle this problem manually as well. Yeah, I know now and realised that a hexagon Die would have been much better and easier to work with.
Will give it another shot again today and hope we can resolve this issue finally.
Keep Your fingers crossed for me Guys. I really need this to come right.
aRM