MetalworkingFun Forum › Machining › General Shop Stuff v
Shop related threads

Thread Modes
Shop related threads
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#22
12-01-2016, 11:12 AM
Andrew,

Malleable iron is simply white iron, which is brittle, that has been annealed to make it malleable. "Cast" is a process term, not a type of iron.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Shop related threads - by Dr Stan - 11-29-2016, 01:03 PM
RE: Shop related threads - by Vinny - 11-29-2016, 01:09 PM
RE: Shop related threads - by Vinny - 11-29-2016, 01:19 PM
RE: Shop related threads - by Mike E. - 11-29-2016, 05:50 PM
RE: Shop related threads - by Old Minger - 11-29-2016, 10:49 PM
RE: Shop related threads - by Dr Stan - 11-29-2016, 11:42 PM
RE: Shop related threads - by Vinny - 11-29-2016, 10:54 PM
RE: Shop related threads - by f350ca - 11-30-2016, 01:47 AM
RE: Shop related threads - by awemawson - 11-30-2016, 02:56 AM
RE: Shop related threads - by pepi - 11-30-2016, 09:29 AM
RE: Shop related threads - by awemawson - 11-30-2016, 12:05 PM
RE: Shop related threads - by Dr Stan - 11-30-2016, 02:45 PM
RE: Shop related threads - by TomG - 11-30-2016, 06:00 PM
RE: Shop related threads - by Dr Stan - 11-30-2016, 08:58 PM
RE: Shop related threads - by Vinny - 11-30-2016, 06:13 PM
RE: Shop related threads - by f350ca - 11-30-2016, 07:36 PM
RE: Shop related threads - by Dr Stan - 11-30-2016, 09:01 PM
RE: Shop related threads - by f350ca - 11-30-2016, 09:17 PM
RE: Shop related threads - by arvidj - 11-30-2016, 10:15 PM
RE: Shop related threads - by awemawson - 12-01-2016, 03:01 AM
RE: Shop related threads - by Dr Stan - 12-01-2016, 10:41 AM
RE: Shop related threads - by TomG - 12-01-2016, 11:12 AM
RE: Shop related threads - by awemawson - 12-01-2016, 11:58 AM
RE: Shop related threads - by Dr Stan - 12-01-2016, 06:03 PM
RE: Shop related threads - by awemawson - 12-02-2016, 02:53 AM
RE: Shop related threads - by Dr Stan - 12-02-2016, 12:46 PM



Users browsing this thread: 3 Guest(s)