MetalworkingFun Forum › Machinery › Lathes v
Gear lever not engaging

Thread Modes
Gear lever not engaging
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#4
11-30-2016, 08:48 PM
Do you have more than one lever out of gear?  If so that can be the problem on a lot of lathes.

Also rotate the spindle as you change gears as its a transmission just not synchronized .
Reply
Thanks given by:


Messages In This Thread
Gear lever not engaging - by aRM - 11-30-2016, 04:20 PM
RE: GEAR LEVER NOT ENGAGING - by f350ca - 11-30-2016, 05:30 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:32 PM
RE: GEAR LEVER NOT ENGAGING - by Vinny - 11-30-2016, 06:19 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:36 PM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 11-30-2016, 08:48 PM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:40 PM
RE: GEAR LEVER NOT ENGAGING - by Mayhem - 12-01-2016, 08:22 AM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 12-01-2016, 10:38 AM
RE: GEAR LEVER NOT ENGAGING - by aRM - 12-01-2016, 10:42 PM
RE: GEAR LEVER NOT ENGAGING - by f350ca - 12-01-2016, 06:21 PM
RE: GEAR LEVER NOT ENGAGING - by Dr Stan - 12-01-2016, 07:26 PM
RE: Gear lever not engaging - by Roadracer_Al - 12-01-2016, 10:04 PM
RE: Gear lever not engaging - by aRM - 12-01-2016, 10:46 PM
RE: Gear lever not engaging - by Dr Stan - 12-01-2016, 10:33 PM
RE: Gear lever not engaging - by aRM - 12-01-2016, 11:02 PM
RE: Gear lever not engaging - by Pete O - 12-02-2016, 03:27 AM
RE: Gear lever not engaging - by aRM - 12-02-2016, 07:05 AM
RE: Gear lever not engaging - by Dr Stan - 12-02-2016, 12:38 PM
RE: Gear lever not engaging - by aRM - 12-02-2016, 01:20 PM
RE: Gear lever not engaging - by aRM - 12-04-2016, 11:21 AM
RE: Gear lever not engaging - by aRM - 12-02-2016, 07:52 AM
RE: Gear lever not engaging - by Pete O - 12-04-2016, 09:10 PM
RE: Gear lever not engaging - by krv3000 - 12-05-2016, 03:43 PM



Users browsing this thread: 4 Guest(s)