MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Oops ... Now It's Too Small

Thread Modes
Help Oops ... Now It's Too Small
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
EdK (11-25-2016)
#4
11-25-2016, 07:15 PM
What Ed said.

Also, when getting close I would take a spring pass (i.e. don't advance the tool, just take another pass).
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Oops ... Now It's Too Small - by arvidj - 11-25-2016, 11:47 AM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 02:04 PM
RE: Oops ... Now It's Too Small - by f350ca - 11-25-2016, 02:17 PM
RE: Oops ... Now It's Too Small - by Mayhem - 11-25-2016, 07:15 PM
RE: Oops ... Now It's Too Small - by pepi - 11-25-2016, 08:31 PM
RE: Oops ... Now It's Too Small - by ieezitin - 11-25-2016, 07:49 PM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 07:57 PM
RE: Oops ... Now It's Too Small - by Dr Stan - 11-25-2016, 08:22 PM
RE: Oops ... Now It's Too Small - by Hopefuldave - 11-25-2016, 08:35 PM
RE: Oops ... Now It's Too Small - by arvidj - 11-26-2016, 08:33 AM
RE: Oops ... Now It's Too Small - by arvidj - 11-30-2016, 04:11 PM



Users browsing this thread: 1 Guest(s)