MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Oops ... Now It's Too Small

Thread Modes
Help Oops ... Now It's Too Small
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#2
11-25-2016, 02:04 PM
Arvid,

Just remove the existing protrusion and make a new one. You may not even have to remove the existing one if the collet chuck has a deep enough recess.

Ed
Reply
Thanks given by:


Messages In This Thread
Oops ... Now It's Too Small - by arvidj - 11-25-2016, 11:47 AM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 02:04 PM
RE: Oops ... Now It's Too Small - by f350ca - 11-25-2016, 02:17 PM
RE: Oops ... Now It's Too Small - by Mayhem - 11-25-2016, 07:15 PM
RE: Oops ... Now It's Too Small - by pepi - 11-25-2016, 08:31 PM
RE: Oops ... Now It's Too Small - by ieezitin - 11-25-2016, 07:49 PM
RE: Oops ... Now It's Too Small - by EdK - 11-25-2016, 07:57 PM
RE: Oops ... Now It's Too Small - by Dr Stan - 11-25-2016, 08:22 PM
RE: Oops ... Now It's Too Small - by Hopefuldave - 11-25-2016, 08:35 PM
RE: Oops ... Now It's Too Small - by arvidj - 11-26-2016, 08:33 AM
RE: Oops ... Now It's Too Small - by arvidj - 11-30-2016, 04:11 PM



Users browsing this thread: 2 Guest(s)