11-21-2016, 04:33 AM
(11-20-2016, 05:01 PM)Dr Stan Wrote: Installing it into the spindle should be a piece of cake. Just lay a piece of wood on top of the table or the vice, set the flycutter on the wood, roughly center the spindle over the cutter, lower the spindle then tighten the draw bar.Hello Doc
BTW, that's a very fine job of machining.
Yes, that's a good idea for installation.
Muchas Gracias for the kind words. All U Guys are indeed overly generous with praise.
Need to go and throw some sand on my dials (face !!)
aRM