Machining an AR15 lower receiver

[TomG]

(06-20-2012, 05:32 PM)Highpower Wrote: I'm waiting for you to get through the barrel portion of your Stevens. I have a buddy that needs the chamber sleeved on his (original). I figured I would wait until you work out the fine details on chambering yours, to see if you run into any snags or oddities.

Willie

Willie,

There has been thinking going on about it. I've found a reasonably priced high pressure oil pump to do the gun drilling. I just need to wait until the proper sized gun drill shows up on eBay and I'll be able to drill the barrel.

I don't think chambering will be much of an issue with a .22 since the case is the same diameter as the bullet.

Tom