Machining an AR15 lower receiver
#11
Meh. It will be a cake walk for you Tom. Smiley-eatdrink004

I hear you about finding the time though. I still need to finish my 2nd and I haven't even started on the third one. Blush

Fall/winter I'll get back into the swing of things again. (Famous last words...)

I'm waiting for you to get through the barrel portion of your Stevens. I have a buddy that needs the chamber sleeved on his (original). I figured I would wait until you work out the fine details on chambering yours, to see if you run into any snags or oddities. Chin

Willie
Willie
Reply
Thanks given by:


Messages In This Thread
Machining an AR15 lower receiver - by Highpower - 06-20-2012, 04:35 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:47 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 05:03 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:55 PM
RE: Machining an AR15 lower receiver - by stevec - 12-01-2013, 07:28 AM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:10 PM
RE: Machining an AR15 lower receiver - by Highpower - 06-20-2012, 05:32 PM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:41 PM
RE: Machining an AR15 lower receiver - by ETC57 - 06-20-2012, 06:12 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-21-2012, 09:12 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 01:49 PM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 04:33 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-21-2012, 03:26 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-22-2012, 10:51 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 10:17 PM
RE: Machining an AR15 lower receiver - by Mayhem - 06-21-2012, 10:30 PM
RE: Machining an AR15 lower receiver - by TomG - 06-22-2012, 06:28 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-22-2012, 09:25 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-29-2012, 08:38 PM
RE: Machining an AR15 lower receiver - by TomG - 06-29-2012, 08:46 PM
RE: Machining an AR15 lower receiver - by d65 - 11-30-2013, 09:49 PM



Users browsing this thread: 3 Guest(s)