(11-12-2016, 09:53 PM)the penguin Wrote: Greg,
hard to say, Jacobs makes about 10 different grades of drill chucks, some are basically crap and others are top of the line. Some of them have machined chuck sides surfaces, others are cheap sheet metal sides, like on some of the cordless drills.
Are you looking for drill chucks for the tailstock of the new lathe??
Is the tailstock MT#3 ??
Yes & yes it is ..
"cheap sheet metal sides" I would run from that for sure, could not give junk like that..
greg
Magazines have issues, everything else has problems