MetalworkingFun Forum › Machining › General Metalworking Discussion v
Flame straightening a shaft

Thread Modes
Flame straightening a shaft
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#8
11-11-2016, 05:32 AM
Mount it between centres in your lathe and rotate until the high spot is facing directly towards you. Take a solid lump of wood and place one end between the ways. Now, use the wood to press against the high spot.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Flame straightening a shaft - by Pete O - 11-10-2016, 02:20 AM
RE: Flame straightening a shaft - by f350ca - 11-10-2016, 12:51 PM
RE: Flame straightening a shaft - by Vinny - 11-10-2016, 06:29 PM
RE: Flame straightening a shaft - by oldskoolron - 11-10-2016, 11:12 PM
RE: Flame straightening a shaft - by Dr Stan - 11-11-2016, 12:26 AM
RE: Flame straightening a shaft - by Pete O - 11-11-2016, 03:03 AM
RE: Flame straightening a shaft - by oldskoolron - 11-11-2016, 04:42 AM
RE: Flame straightening a shaft - by Mayhem - 11-11-2016, 05:32 AM
RE: Flame straightening a shaft - by Vinny - 11-11-2016, 02:41 PM
RE: Flame straightening a shaft - by Dr Stan - 11-13-2016, 10:24 PM
RE: Flame straightening a shaft - by Pete O - 11-14-2016, 01:59 AM
RE: Flame straightening a shaft - by Pete O - 12-11-2016, 06:30 AM



Users browsing this thread: 2 Guest(s)