|
Flame straightening a shaft
|
11-10-2016, 06:29 PM
I haven't tried flame straightening either. When I have something that needs to be straightened I measure the error, add a few thou to it and put that down on one side with the high point up in the shop press.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flame straightening a shaft - by Pete O - 11-10-2016, 02:20 AM
RE: Flame straightening a shaft - by f350ca - 11-10-2016, 12:51 PM
RE: Flame straightening a shaft - by Vinny - 11-10-2016, 06:29 PM
RE: Flame straightening a shaft - by oldskoolron - 11-10-2016, 11:12 PM
RE: Flame straightening a shaft - by Dr Stan - 11-11-2016, 12:26 AM
RE: Flame straightening a shaft - by Pete O - 11-11-2016, 03:03 AM
RE: Flame straightening a shaft - by oldskoolron - 11-11-2016, 04:42 AM
RE: Flame straightening a shaft - by Mayhem - 11-11-2016, 05:32 AM
RE: Flame straightening a shaft - by Vinny - 11-11-2016, 02:41 PM
RE: Flame straightening a shaft - by Dr Stan - 11-13-2016, 10:24 PM
RE: Flame straightening a shaft - by Pete O - 11-14-2016, 01:59 AM
RE: Flame straightening a shaft - by Pete O - 12-11-2016, 06:30 AM
|
