11-10-2016, 12:51 PM
Have never tried flame straightening Pete, could the bend have been caused by torque. Might act differently then a side loaded bend.
Free advice is worth exactly what you payed for it.
Greg
Greg
|
Flame straightening a shaft
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flame straightening a shaft - by Pete O - 11-10-2016, 02:20 AM
RE: Flame straightening a shaft - by f350ca - 11-10-2016, 12:51 PM
RE: Flame straightening a shaft - by Vinny - 11-10-2016, 06:29 PM
RE: Flame straightening a shaft - by oldskoolron - 11-10-2016, 11:12 PM
RE: Flame straightening a shaft - by Dr Stan - 11-11-2016, 12:26 AM
RE: Flame straightening a shaft - by Pete O - 11-11-2016, 03:03 AM
RE: Flame straightening a shaft - by oldskoolron - 11-11-2016, 04:42 AM
RE: Flame straightening a shaft - by Mayhem - 11-11-2016, 05:32 AM
RE: Flame straightening a shaft - by Vinny - 11-11-2016, 02:41 PM
RE: Flame straightening a shaft - by Dr Stan - 11-13-2016, 10:24 PM
RE: Flame straightening a shaft - by Pete O - 11-14-2016, 01:59 AM
RE: Flame straightening a shaft - by Pete O - 12-11-2016, 06:30 AM
|
Users browsing this thread: 2 Guest(s)